Editing the training deck on the train: Wens controller training refined

2026.11.17 ·Hebei, China
Editing the training deck on the train: Wens controller training refined

On the way to service the Wens Group, our engineer revised the controller operation and maintenance deck on the train: temperature setpoints, alarm thresholds, ventilation and heating interlock, troubleshooting.

Background

After a controller is delivered, on-site operation and maintenance training is part of our job. Training is not reading the manual aloud: the climate logic in a pig house and a poultry house is different, and a parameter set one degree off makes ventilation and heating fight each other. This deck is written for the farm manager and the electrician on site, with one goal — that they can set it, judge it and fix the common faults themselves.

What changed in this version

  • Temperature setpoints: ranges by age and season, with a note on what happens when each parameter is raised or lowered.
  • Alarm thresholds: high temperature, low temperature, power failure and sensor fault — what each alarm means and who goes to the house first.
  • Ventilation and heating interlock: the order in which negative pressure, variable-speed fans and heaters start, so the two sides never run at full power against each other.
  • Troubleshooting: arranged as observe the symptom → check the point → replace the part, each step with an on-site photo.

Why it was edited on the train

Days on customer sites, evenings on the road. The questions raised on site, and the points that were not explained clearly enough, go back into the deck while they are still fresh, so the next session is sharper. This trip is a service visit to the Wens Group, and our engineer worked through the deck on the tray table all the way there (see the photo above: the training deck cover).

ItemDetail
ClientWens Group, Hebei (livestock farming)
On-site workController operation and maintenance training
Deck contentsTemperature setpoints · Alarm thresholds · Ventilation interlock · Troubleshooting
StatusDeck under revision during the trip

A note on this work

Selling a controller is only the start. With the right parameters the house temperature stays steady and the swing is small; with the wrong ones the fans and heaters work against each other, and feed conversion and mortality follow. Training is worth the extra hours on the road. For training or retrofit needs, call +86 199 3789 6911.

Send us your site details, get a configuration the same day

Just three numbers: what you raise, how many, and how many houses. We work out outputs and fan count.

Or call 199 3789 6911
微信二维码 Scan on WeChat · send your house type
T P D